Piusi Clear Captor Water/ Particle Fuel Tank Filter

Why do I need a fuel tank filter?

The increasing bio-content in today’s diesel means that the fuel in storage tanks often contains small, but problematic water levels which can cause a nasty sludge to appear. Water contamination is usually one of the main reasons for costly damage to vehicle engines and reduced fuel efficiency, but an effective water filter can be one of the best ways to prevent this. The water tank filter removes any free water from the dispensed fuel, which protects your vehicle engine from failure. Whiles this filter can get a range of particles, you should also consider a particle fuel filter for removing particles down to finer microns.  You might want to consider Piusi Clear Captor particle tank filter as a solution for additional fuel filtration.

How long should a fuel filter last before I need to replace the element?

Unfortunately, there is no exact answer to this question as it all depends on the level of contamination in your fuel. The dirtier the fuel in your tank, the quicker the filter will get full. We advise that you always have a spare filter element on site so that you experience no downtime if your filter is full and blocks.

If you’re experiencing your filter elements blocking a lot quicker than usual, then this may be down to changes in the bio content of diesel. Read our article to find out more. In this case, we recommend considering fuel tank water absorber such as Aquafighter that removes both free and emulsified water directly from the fuel tank.

Why is it important to know your pump flow rate when choosing your filter?

If your pump is too fast for the maximum flow rate of the filter, the filter will keep blocking leaving you unable to dispense. This may also result in the pump running in partial bypass, causing premature wear on the pump vanes and windings. In extreme cases where you have say a 50lpm filter being used with a 150lpm pump, it may even blow the filter element inside rendering it useless. Therefore, if your pump is 70lpm, your filter must be able to cope with at least that.